X-axis won’t stay level

A forum dedicated to the stock LulzBot Mini 3D Printer
Post Reply
Posts: 2
Joined: Wed Aug 01, 2018 1:32 am

X-axis won’t stay level

Post by dase » Fri Aug 10, 2018 12:12 am

Hey all,

Noticed that my new mini2’s x-axis won’t stay level. If I power on the machine, go to the machines menu options and execute the option to level the x-axis it will go through the proceedure to level it. Things are pretty well level as soon as that is done. However, within a minute of the machine being idle the x-axis will go out of level. The left side with the print head will drop. Anyone else seeing this?

Posts: 16
Joined: Mon Aug 24, 2015 9:16 am

Re: X-axis won’t stay level

Post by tacit_caster » Fri Aug 10, 2018 7:50 am

Hello Dase,

Sorry about this issue with the Mini 2, let's see what we can do! If you can send an email to us at support@lulzbot.com there are a few things we would like to check on the machine, and we should get it working shortly.

Posts: 3
Joined: Tue Jan 08, 2019 7:12 pm

Re: X-axis won’t stay level

Post by cmmodeler » Mon Apr 22, 2019 11:39 am

I've had the same issue with my mini 2 since I got it 4 months ago. the x axis needs to be constantly re-leveled. I've had some long prints fail after a couple of hours and I suspect that the x axis has gone out of level during the print.

it also frequently drives to the left very hard until the machine halts itself. I've taken it back to the factory for this issue and they tightened something (I don't know what). Now it only does this some of the time instead of always. There is still something basically wrong with this machine.

I am less than completely happy with my mini 2.

Posts: 5
Joined: Fri May 10, 2019 10:56 am

Re: X-axis won’t stay level

Post by JohnQuix » Mon Jul 01, 2019 8:02 pm

I have had the same issue with my Mini 2. I was just told to "Make sure my PEI was clean" (?!?) and that "It's a good idea to level the X-axis before every print"

No real response from support as to the obvious defect of the design just kind of ignored the whole thing and talked past me.

I did find that for me running the X-Axis leveling before every print has lessened serious issues due to this problem. It's not what I would have expected from a printer in this price range but support has done a great job of bludgeoning me into submission with stock response cut and pastes that have nothing to do with my problems.

Post Reply