Printing Brackets for Enclosure

A forum dedicated to the stock LulzBot Mini 3D Printer
Post Reply
jaybeckham
Posts: 48
Joined: Wed May 04, 2016 3:43 pm

Printing Brackets for Enclosure

Post by jaybeckham » Sat Dec 15, 2018 9:39 am

Instructions mention 4 or more shells. How do I specific the number of shells?

Thanks

b-morgan
Posts: 305
Joined: Fri Aug 11, 2017 8:53 am

Re: Printing Brackets for Enclosure

Post by b-morgan » Sat Dec 15, 2018 9:54 am

You might want to mention what slicer (and version) you are using. What printer might help as well.

jaybeckham
Posts: 48
Joined: Wed May 04, 2016 3:43 pm

Re: Printing Brackets for Enclosure

Post by jaybeckham » Sat Dec 15, 2018 9:57 am

I am using Cura LutzBot Edition 3.2.23

I have set the shell layers to 4 I assume that is what that were saying in the instructions.

b-morgan
Posts: 305
Joined: Fri Aug 11, 2017 8:53 am

Re: Printing Brackets for Enclosure

Post by b-morgan » Sat Dec 15, 2018 10:01 am

Yes, you have identified the correct setting.

jaybeckham
Posts: 48
Joined: Wed May 04, 2016 3:43 pm

Re: Printing Brackets for Enclosure

Post by jaybeckham » Sat Dec 15, 2018 10:01 am

Thanks, just started the print.

Post Reply