I’ve had my Mini for about 9-10 months and it works wonderfully. However, I’ve noticed over the past couple days that the bed levelling no longer touches at the same place on the washers that it used to. It used to kind of touch all 4 washers on the quadrant closest to the center of the bed - always right in the middle of that quarter. But now it’s as if the bed is off somehow because the first washer it touches on the back inner quarter and the front two washers it touches right on the very edge and sometimes the angled part of the hot end is what touches instead of the end. it’s as if the bed has moved about 4-5mm forward. It does manage to wipe in the proper place though, so I’m not sure what’s happened. I haven’t changed the firmware recently and because I run it off an Octopi (which I’ve been doing for 5-6 months) since I don’t have a computer near it, I can’t easily run diagnostics.
Any suggestions on what might be causing this, physical issues to look for or any settings I should adjust? It works fine about 50% of the time in that it finds the washers, even just barely, but sometimes, when it’s the angled part, it does the cleaning routine enough times to reset the printer.
Thanks for the help!