I'm wondering if anyone has had good luck printing using the new Aerostruder Micro with the Mini 1.
In particular, the .05mm layer setting.
I can't do it no matter what I try, and in all 3 preset layer heights, the prints seem way more brittle at the layers.
I did find some unopened Polylite PLA, which I think is the main recommended filament.
Has anyone gotten a .05mm layer print to work? If so, could you upload the GCODE?
A forum dedicated to the stock LulzBot Mini 3D Printer
2 posts • Page 1 of 1
It'll help if we can see what you are trying to print. Share the model, or at least images and we'll be able to make some recommendations.