Printer disconnecting mid print

A forum dedicated to the stock LulzBot Mini 3D Printer
Post Reply
Makerprincess
Posts: 1
Joined: Wed Feb 06, 2019 4:49 pm

Printer disconnecting mid print

Post by Makerprincess » Wed Feb 06, 2019 5:02 pm

My printer disconnected from Cura and stopped printing mid print a few days ago. Since then any time I try to start a print it disconnects during the start gcode while it is doing its initial heating of the extruder before wiping. It’s not always the same temperature at which it stops either. Additionally, if I just set it to heat up manually it will heat to whichever temperature I specify but something during its start phase before printing is causing issues.

I have updated the firmware and tried a different cord and a different USB port and a different computer. It will take commands from Cura when I connect it, but once it stops during the start gcode it disconnects from Cura completely.

I’m out of ideas, help!

Post Reply