Hi!
I have been working with two Taz 4’s and have been experiencing an issue on both printers. That being said, I’m assuming I’m doing something wrong, and I was hoping someone might be able to point out my mistake.
I have been having issues with the layers of my prints in ABS not adhering to each other very well (see photos).
I have just been using a large plastic bag to try and keep drafts from warping the piece. I am currently ordering some 80/20 to build an enclosure to match the printer.
Is it likely that I need to keep the printer in a warmer area? It is currently in a room that is about 70F. Or if I build a better enclosure, should that be sufficient?
Also, the reason why I printed the model in that orientation was to reduce support material. Is the overall height of the piece a detriment to the print since it’s further away from the bed?