I’ve now spent over $100 in little parts needed for my TAZ. I seem to be accumulating boxes of 50 or 100 parts when I only need one or two. Rather than put everyone else through the same mess, I’m going to list what I have. Feel free to PM me if you need something. I’m going to try to list the part number from Aleph Objects as well as what it is used for.
HD-BT0010 - M4 x 20 Bolt, SHCS Black-Oxide
HD-BT0049/HD-MS0055 - M5 x 20 Bolt, SHCS Black_Oxide with thumb screw knob (Thumb screw for Flexystruder)
(McMaster-Carr link: http://www.mcmaster.com/#96016a245/=xjsgjn) (should buy shorter one - maybe 12mm or 16mm)
HD-MS0060 - M5-.8 11mm Heatset Insert (Thumb screw for Flexystruder screws into this)
HD-TB0006 - .25"ODx.125"ID PTFE tube (~2.5") (Used by Flexystruder)
(McMaster-Carr link: http://www.mcmaster.com/#8547k23/=xjs8um)
HD-MS0030 - M3-.5 3.8mm Heatset Insert (Used for mounting fan on extruders)
TL-CS0083 - EMI/RFI-Shield Heat-Shrink Tubing 3/16" ID Before, 3/32" ID After, 48" L, Black (Goes around wiring next to extruder connectors)
PC-RE0007 - Heat Resistor, 4.7 Ohm (Heating resistor for Budaschnozzle)
EL-MS0012 - Wire Ferrules 22-20 AWG (crimp pieces for thermistor)
EL-MS0014 - Noninsulated Wire Ferrule, 16 AWG, .28" Pin Length (crimp pieces for Budaschnozzle heating resistor)
I will update this list over time with any new parts I get or to fill in missing information.