TAZ Mini Print Area

Have questions? Want advice?
Post Reply
wmgeorge64
Posts: 410
Joined: Wed May 27, 2015 7:28 pm

TAZ Mini Print Area

Post by wmgeorge64 » Wed Jun 10, 2015 4:41 pm

TAZ Mini Print area. So its suppose to print 155x155 mm, but a 150 mm wide project did not get the Gold ok seal of approval in Cura. I had to scale it back to 145 mm to get it ready to go. So is this more or less normal?
ULS Laser . Retired master Electrician in Iowa USA Lots of Hobbies

BaltimoreBully
Posts: 47
Joined: Sun Feb 22, 2015 10:43 am

Re: TAZ Mini Print Area

Post by BaltimoreBully » Wed Jun 10, 2015 5:12 pm

There is a similar post to this in the Mini section of the forums. You have to scale back the skirt in order to be able to use the full print area. I believe instructions are in the other post.

wmgeorge64
Posts: 410
Joined: Wed May 27, 2015 7:28 pm

Re: TAZ Mini Print Area

Post by wmgeorge64 » Wed Jun 10, 2015 10:20 pm

Thanks, did not even know the other Forum existed. Will be reading up there.
ULS Laser . Retired master Electrician in Iowa USA Lots of Hobbies

Post Reply