Page 1 of 1

TAZ Mini Print Area

Posted: Wed Jun 10, 2015 4:41 pm
by wmgeorge64
TAZ Mini Print area. So its suppose to print 155x155 mm, but a 150 mm wide project did not get the Gold ok seal of approval in Cura. I had to scale it back to 145 mm to get it ready to go. So is this more or less normal?

Re: TAZ Mini Print Area

Posted: Wed Jun 10, 2015 5:12 pm
by BaltimoreBully
There is a similar post to this in the Mini section of the forums. You have to scale back the skirt in order to be able to use the full print area. I believe instructions are in the other post.

Re: TAZ Mini Print Area

Posted: Wed Jun 10, 2015 10:20 pm
by wmgeorge64
Thanks, did not even know the other Forum existed. Will be reading up there.