Hotbed cleaning after printing

Before I decided to post this question, I searched for the answer, but was not able to find the answer to my question.
I know the Acetone and Filament solution helps provide a sticky substance on the Hotbed,but what is the best way to clean your Hotbed after doing a print or several prints?

Acetone by itself on folded up paper towels works well

Ok, thank you Cale for the information.
I was not sure to use just Acetone or some other cleaning solvent like Windex. I will also make sure that the Printer is not power up at all for this cleaning procedure.

I just use a really thin cheese wedge to scrape the residue off. so long as you are printing the same color I find you don’t have to be too careful.