Hello all, I’m hoping I can get some good advice here about a couple of issues I’ve been having with my figures/printer.
I’m using a TAZ 6 and everything was printing fine until…
Seemingly out of the blue the nozzle started leaking. I did my due diligence and searched google for any reasons/fixes for the issue and have since taken apart the extruder head, cleaned the throat and heat plate and put everything back together but the problem persists. After that I tried a few test prints and after dealing with the constant nozzle leak I’ve been noticing the head is having a hard time pushing filament through the nozzle (probably due to hardened filament from the leak) to create the border layer of the print and then after getting a constant flow one half of the print looks like garbage and the other half looks fine.
Anything else I can try or are there some calibrations I need to make?