Hi all. Trying to figure out a bed leveling issue with my Lulzbot Mini. I know that it self-levels by touching the corners but the front right corner is constantly off.
Here are the average measurements for my last 15 prints:
Bed z:0.00 y:0.00 z:-1.487
Bed z:160.00 y:0.00 z:-1.236
Bed z:160.00 y:160.00 z:-1.554
Bed z:0.00 y:160.00 z:-1.479
It seems that the front right corner is always off with the other corners being pretty darn close.
Since the bed is self-leveling is this an issue I should worry about? Is there anything I can do to fix it? Should I replace the ninja-flex corner hold?