Hello!
I have a relatively new Lulzbot mini which I have only used to make around 12 prints in the last 2-3 months. Everything was perfect until today.
I preheat the extruder and build plate. When I hit “print” the temperature of the extruder immediately begins to drop, and continues to drop until it reaches 0.
I have checked all of the external connections.
I tested this without heating the build plate, and the same thing occurred.
It does not seem to take longer or shorter to reach the target temperature than it normally has.
I unplugged and replugged everything.
I ensured the firmware and Cura software is up-to-date and restarted my computer.
What can I do?
Thanks!