TAZ6 Thermocouple with MAX6675 installation

Have questions? Want advice?
mikronano
Posts: 63
Joined: Wed May 13, 2015 2:42 pm
Location: Chicago, IL

Re: TAZ6 Thermocouple with MAX6675 installation

Post by mikronano » Tue May 01, 2018 12:44 pm

That's strange...
You could take a look in this: https://ohai.lulzbot.com/project/firmwa ... e-flashing.
Although, from what you're saying, if it was a miscommunication or miscompile issue, then you should get an error message from Arduino and nothing would have been uploaded. It seems to me that something in your code passes the Arduino tests and checks but it doesn't work with TAZ. Like some pins are conflicting on board.
Press a key to continue or any other key to quit

lmen31
Posts: 9
Joined: Thu Dec 14, 2017 2:31 pm

Re: TAZ6 Thermocouple with MAX6675 installation

Post by lmen31 » Wed May 09, 2018 1:08 pm

Thanks for replying

I fixed the upload problem. I watch this video and got the idea: https://www.youtube.com/watch?v=0pt_b2ZizQM

I uncommented this line to get the sounds from the button in the Configuration.h tab:

#define SPEAKER

and also this line:

#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER

But know that I'm trying to make changes to the temp sensor 0 (-2, because it is a max6675) I get this error. I'm using a Taz 6.

MAX6675_SS (required for TEMP_SENSOR_0) not defined for this board.

I hope that someone that had the same problem could help me.

Thanks

Post Reply