Page 1 of 1

how to stop Taz 6 and mini from autoleveling?

Posted: Sun Feb 11, 2018 8:08 pm
by robotswordfight
Hi all,

Let's say in theory my bed is level and ignore any cons of not auto leveling.

What would be the procedure to stop running the bed leveling command (G29 I think), and to just start printing based on a known good starting z height?

I have two main reasons for this, but one them is using a ruby nozzle.

Thanks,
John

Re: how to stop Taz 6 and mini from autoleveling?

Posted: Wed Feb 28, 2018 5:18 pm
by Aha
Quite simple actually: check the program you're using for slicing. You could also remove it from the first couple lines of each gcode output.

But if you're using simplify3d there's a tab for start and end gcode. Cura has it under machine settings. Settings, printer, manage settings, machine settings, start gcode on the left. Then there should be a clearly marked area for probing that is the leveling code.

Re: how to stop Taz 6 and mini from autoleveling?

Posted: Tue May 15, 2018 12:54 pm
by Cam
Right, but does the printer retain the leveling information? Or is there some magic M code I need to set somewhere?

My Mini is so finicky with giving me a "perfect" autolevel that I've lost count of the hours I've wasted restarting prints. I'd be perfectly happy with a "good enough by default" option.

Re: how to stop Taz 6 and mini from autoleveling?

Posted: Tue May 15, 2018 2:30 pm
by b-morgan
I believe the printer will retain the settings in a single session but the results are not stored in EEPROM. "M420 V" will tell you if bed leveling is on or off and show you the bed level correction matrix.