Hello,
Bought this TAZ 6, and i’ve tried hundreds of things , read so many articles, tried diffrent PLA, tried diffrent slicers, layer thickness/temp, and the printer won’t print any good print like my Ultimakers do. How much i fiddle arround with this printer, its not making any “Good” print. The cylinder Z seam is terrible and i put some pictures up here how it’s printing square prints.
However, im totaly in love with this taz 6 and i think it can be a beast. i tried so much things even rebuild the printer, it was setup correctly and after rebuild it has the same problem. it blobs allot, not extruding in some places which leaves a sudden hole in my print.
so i think the 0.50 nozzle is destroyed. i’ve bought a 0.35 nozzle from lulzbot and going to install this. but the instructions says it’s not direclty compatible with the TAZ 6
Here’s the one i bought:
https://www.lulzbot.com/store/parts/lulzbot-v2-hexagon-hot-end
Can anyone tell me what’s not compatible and what i need to make it compatible for the TAZ6 ? it’s strange cause the details says it’s compatible.
This Photos are taken from a print, printed on Temp190 and the standard quality in lulzbot cura version.