Taz 6 not hitting auto level washers at glass corners

Have questions? Want advice?
Post Reply
mrmatt68
Posts: 6
Joined: Sat Jun 11, 2016 9:36 am

Taz 6 not hitting auto level washers at glass corners

Post by mrmatt68 » Sun Sep 30, 2018 7:40 am

I have a taz 6 and when it runs the autolevel before each print the head is not at the center of the z height sensor and gets worse as it moves around to the 4 corners almost missing the 2 washer in the corner. The belts are tight and nothing seems loose and the x and y are square to each other. Its like the limit switches have moved but i don't see how that is possible.

Any ideas?

Thanks,

Matt

Ehoff
Aleph Objects | LulzBot
Posts: 57
Joined: Fri Sep 08, 2017 1:34 pm

Re: Taz 6 not hitting auto level washers at glass corners

Post by Ehoff » Sun Sep 30, 2018 9:37 am

It sounds like the printer might have come out of square. We have a guide that goes over squaring the machine here: https://ohai.lulzbot.com/project/squari ... bulletins/

Post Reply