We recently bought a Lulzbot Mini 2 for our engineering classroom about 2 months ago. The printer consistently has problems leveling the build plate: it first goes to the back left corner and pushes the entire build plate down by a mm or two, then goes to the back right corner and misses the washer and slams the rest of the print head on the washer. Is there anyway to fix this so we can continue to use the printer? We voided our warranty already because someone disassembled the entire print head.
Contact us over at support we should be able to help you out.
Email: support@lulzbot.com
Phone: +1-970-377-1111 Ext. 610
Hours: Available 7 days a week, Monday through Friday: 8:00 a.m. to midnight EST (1200-0400 GMT), Saturday and Sunday: 9:00 a.m. to 7:30 p.m EST (1300-2330 GMT). Closed on most U.S. holidays.
It’s possible that you didn’t void the warranty. Just disassembling the tool-head shouldn’t void the warranty unless you cause some additional damage along the way. Even then the warranty for the rest of the printer would still be in tact, just not the additional damage on the tool-head.