TAZ hot end leaks...

Have questions? Want advice?
T0rave
Posts: 1
Joined: Wed Dec 31, 2014 11:07 am

Re: TAZ hot end leaks...

Post by T0rave » Wed Dec 31, 2014 11:11 am

I just got my taz4 and am having the same issue with over flow/ leaking, this is the second time its done this, it'll start the print fine but on longer prints will leak, I'm going to try and see if the tape on threads will help for now.

geneb
Posts: 63
Joined: Thu May 02, 2013 7:59 am

Re: TAZ hot end leaks...

Post by geneb » Wed Dec 31, 2014 11:47 am

It's my understanding that some of the hot ends were equipped with a section of PTFE that's too short. If your leak is resulting in puddling on top of the heater block, you should contact support about it.

g.

Post Reply