TAZ 4 detail photos

Would someone be so kind as to post photos of the TAZ 4 changes relative to the TAZ 3?

Thanks,

TM

This one shows a good shot of the changes to the Z axis. The threaded rod is replaced by a leadscrew, the leadscrew is ssupported and constrained by bearings top and bottom, and a helical coupler replaces the tubing. The Actual Z nut mount is now a solid unit, not a spring as the leadscrew does not need the compensation that the threaded rod sometimes required. You can also see the new Y axis frame to main frame connectors just under the build plate. The power supply and electronics enclosure also changed significantly.
http://i1.wp.com/www.serialhobbyism.com/wp-content/uploads/2014/05/photo-1.jpg

Here’s the full review that picture came from that someone else did.
http://www.serialhobbyism.com/the-new-lulzbot-taz-4-3d-printer/

I haven’t quite finished the conversion of my 3.2 to a 4 yet due to waiting on the bearings to ship.

It Might be a good idea to upgrade mine. These parts look more substantial then the 3. Thanks for the photos. Lulzbot could sell upgrade kits for this. I looked at some of the prints. It looks like I’ll have to machine the x plates and make some new rods but the rest of it looks like printed stuff.

there is a printable replacement top plate too.