Hi,
I’m trying to compile a list of all the debugging tasks one goes through to collect data inorder to diagnose a Lulzbot failure in one thread. If anyone wants to contribute I’d love to hear from you.
I have included some “starter buckets” to organize why you’d perform a debugging task.
~> Please post/add new buckets in the same format below.
*Extruder not Extruding:
– i.e. resistance meter testing heat resistor
*Heatbed not heating / not maintaining consistent temperature:
– i.e. Run GCode command to retrieve PID values for bed
*Filament Feeder not feeding correctly/consistently:
– i.e. Finding ESteps value
*Poor ABS bed adhesion
– Unleveled bed when gliding extruder across
THANKS!