Bringing back a Single Extruder Lulzbot Mini that has not been in use for a while. Updated the firmware and now trying to recalibrate esteps, but I can't seem to update the value.
I have been putting "M92 E830" into the console. No response. When I enter M501 to check for a change, it still shows the same number as before. I tried saving the value with M500 and then rechecking M501. No change. Also tried the same for "M92 E830 T0" in case it wanted an extruder number. Still no change. (I did connect to the printer, and I can print, although it puts out too much filament.)
What am I missing?
Thanks for helping!
Have questions? Want advice?
2 posts • Page 1 of 1