Hey guys,
I just received a second hand Taz 6. It wasn’t packaged great and I had to replace some of the 3d printed parts on it (before i could print anything).
Once all together and on the desk, I attempt to print a test print, however after auto homing, it fails due to the hot end unable to make contact with the first corner washer during auto level (and the other 3 thereafter).
It seems as though the bed is too low.
I have check that the X axis is flat, which it is. The low height of the bed seems to be the same across the print bed. I have also noticed that even when it attempts to wipe the nozzle, it is barely touching the cleaning element.
I have tried different print profiles and even checking whether the frame is square or not.
Any help here is greatly appreciated.