Page 1 of 1

Ultimaker Cura 4.2 commands

Posted: Tue Sep 10, 2019 3:51 pm
by NebNorse
So I haves asked over in Ultimakers forum, but havr not gotten a reply back yet. Thought I would ask here as well.

My Taz 6 has the dual v2 head and what I am looking for is the command line for Cura 4.2 to pull nozzle 2s temp into the G-Code. In the Lulzbot Cura 3.6 it is "{material_print_temperature_layer_0_1}". This does not work in Cura 4.2

I have found that Cura 4.2 handles complex prints easier and does not crash like 3.6 I can keep modifying the G-Code, but this is a huge amount of extra work. If I can just find the right command, it would be so much simpler.

Re: Ultimaker Cura 4.2 commands

Posted: Fri Sep 13, 2019 4:04 pm
by radensb
You have just discovered one of the many back-end changes between the Lulzbot CURA and Ultimaker editions. CURA LE has modified python code that allows it to detect and substitute a greater number of parameters in the GCODE, including the extruder specific temperature layer 0 temps. I am not sure why these additions have not been merged back into the Ultimaker repo, or why Ultimaker devs have not implemented something similar themselves because I believe this is a basic dual extruder level of control. The LE CURA used to merge their upgrades back into the Ultimaker repo, but I am not sure why deviations like this still exist. In short, this means that you cannot use the LE custom GCODE blocks in the Ultimaker version unless you ensure that all the parameters are recognized.

Re: Ultimaker Cura 4.2 commands

Posted: Thu Sep 19, 2019 7:21 pm
by b-morgan
I'd look at the start code for one of Ultimaker's Dual Extruder printers to see if there are variables there that you could use.