Current LulzBot Slic3r Configurations

General Software
1

You can find the current base Slic3r configurations on our download server. You can use the configurations to get started when you change your hardware- such as using a different sized nozzle.

Slic3r Configs

AO-100
[]0.5mm nozzle - point5mm.ini
[]0.35mm nozzle - point35mm.ini
[*]0.25mm nozzle - point25mm.ini

AO-101
[]3mm filament, 0.5mm nozzle, 0.3mm layer height - 3mm_pt5-nzl_pt3-lyr.ini
[]3mm filament, 0.5mm nozzle, 0.4 layer height - 3mm_pt5-nzl_pt4-lyr.ini
[]3mm filament, 0.35mm nozzle, 0.25 layer height - 3mm_pt35-nzl_pt25-lyr.ini
[]3mm filament, 0.25mm nozzle, 0.1mm layer height - 3mm_pt25-nzl_pt1-lyr.ini

Use the File>Import Config menu to import these Slic3r configs. Review and adjust your settings as necessary.

2

Is there any word if Kilment will be integrating the new slicer into Printrun?

3

You can change the slicer in Printrun under the Options menu. I haven’t tried to integrate it yet, I’ve always used a separate slicer.

4

Has anyone looked into calculating a more accurate Z layer height for the Acme 3/8-12 leadscrews?

EG: http://calculator.josefprusa.cz/

But that calculator doesn’t include the 3/8-12 leadscrews for Z.