Gcodes... Where to find them?

Howdy folks,

Just wondering if there was a comprehensive list of the standard Gcodes that are used for the Mini?

These are the ones that I have found so far…

M501 (to see the current values)
M92 E800 (Change 800 to whatever your value is)
M500 (Saves your changes)
M501 (Verify the changes stayed)
G1 E100 F30 (extrudes 100mm of filament at 30mm/s

Much appreciated!

Here’s the Gcode list: http://reprap.org/wiki/G-code

Thanks for that!

However, I was hoping for more a beginners list. Like a specific generic list of gcodes that are commonly used by users to perform the more common functions. Anything like that?

Do a Google for G Codes, you will find all the info you need.

OK good to know, thank you!