Slic3r Profiles and Start/Stop Code

Hi,

I am trying to use slic3r to generate the G-code and send to octopi and while it sends a file when it prints it homes z then wipes and then does the bed level routine and stops. I added the start/stop codes from cura to slic3r so it should be doing that but why is it not running the part? The file is 110 Megs. I downloaded the profiles in ABS to slic3r and setup everything that made sense but i cannot seem to get a part to actually run. Do i need to setup the start stop g-code in octoprint?

Thanks,

Matt