Been running some version of Cura on Win 10 for a good while with no issues. Ran perfectly last Thursday. Tried to start it today and it spins a minute and then nothing. I rebooted and get the same. I uninstalled, rebooted, reinstalled, rebooted and still get the same. That was with version 2.4. I uninstalled and got 2.6 and tried it all again with 2.6.
Looks like it installed fine, I see the spinner for a couple of seconds and nothing.
CTRL-ALT-DELETE never shows cura running.
Multiple versions ran perfectly on the same system for over a year and then it is now completely dead. I haven’t installed anything. I ran virus checkers and found nothing, etc etc.
Any ideas why it would just stop executing or any way to troubleshoot?
I have this problem too. I just got a new laptop with win 10 and installed the latest downloadable (21.0.8) of Cura Lulzbot edition to use with my Taz5. When I try to boot it I get the Lulzbot splash screen then nothing. The event log shows and application error and that CuraEngine.exe faults.