Is macOS High Sierra supposed to be supported yet?
I do have the Lulzbot connected, it does appear in System Profiler [RAMBo / UltiMachine (ultimachine.com)], but neither Cura nor Cura Beta show the printer as connected. I’ve tried rebooting the printer, Mac and using a different cord to no avail.
Any ideas?
Update, I was able to get the original Cura working by removing both versions fully, re-downloading and using only the original Cura.
I’m still unable to get the beta to detect anything. I found a post saying that both versions cannot work side-by-side:
- On Linux, Cura 2.3 cannot be installed side by side with existing Cura Original
From: https://forum.lulzbot.com/t/using-cura-2-3-1-with-lulzbot-3d-printers/4158/1