Using the 21.08 Lulzbot edition.
Opened the rock2pus gcode fine, then saved it on the SD card. Ran that one after a bit of z-axis adjusting and it looks good.
Opened the 3dbenchy and changed to polylite filament (file is for nGen and I used all the sample up) as I wanted to see how their default settings, 205 vs the 230 reccommended, work for polylite.
The icon opens the save window, but nothing gets saved whether I chose the SD card or custom file destination. Hit OK and it disappears without saving anything.
Copied it to my c drive and it opens, but still wont save any changes.
Any way to get around this? Do I need to do something within Cura to make it save?
Get answers & advice for all of your 3D printing & Free Software needs here!
1 post • Page 1 of 1