I just installed a dual extruder on my TAZ 6 and was having a problem with the calibration print using Cura 2 Lulzbot Edition beta and Marlin 188.8.131.52 which led me to perform the following experiment. First, I installed 184.108.40.206 and switched to Cura 21.08. I then issued these commands manually:
(home, set absolute, auto-level etc.)
M114 ;Show position of first extruder
M114 ;Show position of second extruder
Since the description of M114 says "Get the current position of the active nozzle. Includes stepper values", I expected the first M114 to return E0 and the second M114 to return E10. Instead, both return E10.
Since the test/calibration print works (in 220.127.116.11), I'm assuming that the Marlin firmware is properly maintaining the E values for each extruder internally. I just can't see it on the outside. Are there other commands I should be using?
The test/calibration print "fails" in 18.104.22.168 as the start gcode retracts both extruders, wipes, auto-levels, and then attempts to reset both extruders back to zero. T1 is successful, T0 doesn't move. The T0 portion of the first layer is printing air for a quite a while before the filament actually reaches the nozzle again. I'll report this as a bug as soon as I develop some confidence in my method.
Get answers & advice for all of your 3D printing & Free Software needs here!
1 post • Page 1 of 1