Cura 2.2.66 Thermal Runaway Error on MAC OS

Get answers & advice for all of your 3D printing & Free Software needs here!
Post Reply
Farny3D
Posts: 36
Joined: Wed Jan 27, 2016 8:14 pm

Cura 2.2.66 Thermal Runaway Error on MAC OS

Post by Farny3D » Mon Feb 05, 2018 11:29 am

Prints start fine until about the 3rd layer then I get the Thermal Runaway E0 Please Reset error.
Im on a Taz5 with the .05mm Hexagon extruder. Just upgraded from Cura 21.08 probably going back if I cant get this corrected because the issue seems dumb and If I have to go through the process of telling my Arduino IDE that the RAMBo board is there now, which it always recognized before, Im over it. Why cant I flash the firmware with the bug fixes from Cura? Why cant they just release a stable version of this program and let people use it? Why does it constantly need tweaking and recoding?

Post Reply