Duel Extruder v2 Build Size Cura 2 smaller?

General Software
1

I’ve had the v2 Duel extruder for a while but never used it on Cura 2. I have found the build space is much smaller in this version. Is there any way to adjust this? I don’t care if the nozzle not printing goes over the heated bed on the Y-axis.

2

We are sorry to hear about that, this change in space was not intentional. Are you using a TAZ 5 or a TAZ 6? Which version of Cura did you run into this on?

3

I’m using at Taz 5 with Cura 2.6.69