How do I adjust the 0,0 location of the printer?
I adjusted the bed size settings to 300x300 the actual size of the bed. The only thing I will print all the way to the edge would be the skirt, so I'm not too worried about a bit of plastic going over the edge.
When I make this change, the printed objects appear in the center of the bed on the Cura screen, but when printed are several centimeters to the right, and towards the back of the machine. This means I can't use the entire print bed.
I can't find any adjustments in cura for this.
Get answers & advice for all of your 3D printing & Free Software needs here!
1 post • Page 1 of 1