View Mode: Layers get stuck at 50%

Get answers & advice for all of your 3D printing & Free Software needs here!
Post Reply
iguanaman
Posts: 57
Joined: Tue Feb 20, 2018 6:09 pm

View Mode: Layers get stuck at 50%

Post by iguanaman » Sat Jun 23, 2018 2:39 pm

I've have an STL that I loaded from Thingiverse. It is a 10 inch moon and the file size is about 50 Meg. It was able to slice the file and save the gcode (which ended up at 449 Meg.)

When I select the View Mode: Layers it gets to the 50% mark fairly quickly and then gets stuck. I've waited several minutes and I don't see it getting any further. Are certain STL files simply too large for the application?

Post Reply