Have installed Cura 3.2.21 on my Mac Book. All seems to be going well, OctoPrint working fine as well. However when connected directly to my Mini there seems to be a problem with the Console window.
The window opens, but there is no vertical scroll bar and the window is fixed vertically below the bottom of the physical screen. So I cannot get to the console window command input line. I have tried all of my Mac OS Set up tricks, but nothing works. I can see the software geberated G code commands so the window is receiving input. All the other windows are fine. Does anyone have any ideas?
Get answers & advice for all of your 3D printing & Free Software needs here!
1 post • Page 1 of 1