Restore Failsafe - TAZ 6

Get answers & advice for all of your 3D printing & Free Software needs here!
Post Reply
Teriel7
Posts: 1
Joined: Wed Sep 12, 2018 9:33 pm

Restore Failsafe - TAZ 6

Post by Teriel7 » Wed Sep 12, 2018 9:36 pm

Hello,

I've been having issues with my TAZ 6 and the z offset. I tried a lot of things but I just couldn't get it to work, so out of shear frustration, I hit restore failsafe. Now I haven't tried printing again with it, as I went to go see if the settings were the same and they were all some weird high and low numbers. Is there a place I can get these numbers again for like Vmax and min etc?

Thanks in advance.

Post Reply