settings to compile own firmware

Get answers & advice for all of your 3D printing & Free Software needs here!
Post Reply
dysan
Posts: 6
Joined: Fri May 18, 2018 8:53 am

settings to compile own firmware

Post by dysan » Sun Oct 07, 2018 6:15 pm

I would like to compile firmware for my Taz6 using the latest Marlin but I don't know what settings and libraries are needed for this or if there are preset config.h and adv.h files available to copy and paste in place of the stock marlin files??

I am fairly new at this and have done it with my Ender-3 printer which is just a mess with one but I really want to activate linear advance on my taz 6 printer and use the latest marlin.

Any guides for the taz or assitance would be appreciated.

Thanks

Post Reply