Clean Nozzle for Taz 5

Get answers & advice for all of your 3D printing & Free Software needs here!
Post Reply
2con
Posts: 110
Joined: Sat Dec 07, 2013 11:35 pm

Clean Nozzle for Taz 5

Post by 2con » Mon Oct 22, 2018 7:16 pm

Hi All,

Is it possible to modify the gcode or settings in Cura 3.2.27 so that I can press the button for 'wipe the nozzle' ?

I have a Taz 5 and currently i get an error and it will not let me use this button as i do not have the Taz 6 firmware installed.

I have the wiper installed for a long time and I've set it up before as a gcode command, but that was years ago with repeteir and I would love to use this button instead of setting it all up again.

Thanks!
Taz 2 since crowdfunding 2013
-complete upgrade to Taz 6, swing-arm auto leveling, anti-z wobble installed, hardened steel rods with all linear bearings, vibration dampers, auto cleaning, hexagonal noz upgrade
To do:
-Cable carriers

Post Reply