I have a A101 with the Rambo 1.0 board and Marlin 1.0.
The schematic shows 2 fan outputs.
M106 turns on fan-0. But, I am trying to use the second fan output and M106P1 doesn't turn it on. (In fact, it M106<anything> just turns on fan-0)
Is there a way to turn on the fan-1 output?
The board appears to have the components shown in the schematic.
I took a quick look at the marlin code, but nothing jumped out.
Is a later version of Marlin required? If so what is the last version that will run on the Rambo 1.0 board? (And, if so where do I get it?) (And can I just use the Arduino ide to upload it?)
Get answers & advice for all of your 3D printing & Free Software needs here!
1 post • Page 1 of 1