I wanted to try out Cura after using Simplify 3D for so long, so I downloaded the latest Lulzbot version but noticed there is no TAZ 4 listed.
Now, my TAZ 4 has a E3D hotend as well.
Any hep setting up Cura properly?
Keep in mind while not a 100% noob with Cura I am a 90% noob at Cura.
Get answers & advice for all of your 3D printing & Free Software needs here!
2 posts • Page 1 of 1
Depending on your setup, you can start with the TAZ 5 profiles. Ideally, you'll have moved away from the green PET film to a PEI print surface. You may need to adjust some of the built-in temps to better suit your exact hot end setup and performance.