Page 1 of 1

Interface layer Floor Missing?

Posted: Thu Dec 27, 2018 9:27 pm
by radensb
I am playing with the interface floor and roof features and noticed something that I don't understand. It seems that under certain conditions, the interface floor does not get printed. Is there a setting that needs to be adjusted? I believe it is due to the aggressive angle of the model at the location, but I cannot find the proper setting to tweak this.
I have also noticed other situations where support layers seem to get printed in mid-air. Of course, this only occurs when I slice a massive object that takes a full day to print....

Appreciate the help!

Re: Interface layer Floor Missing?

Posted: Thu Jan 10, 2019 1:04 pm
by Orias
It'll help if you can share the model. You can also reach out to the support team at for assistance with tweaking your slicing settings.