Page 1 of 1

Droopy Overhangs

Posted: Tue Feb 12, 2019 7:49 am
by underdog1924
I've tried printing these items on a Lulzbot Taz 4 and Lulzbot Mini 1. Both have droopy overhangs. The slicing programs determine that supports are not needed so I'm not quite sure what to do here. Any suggestions?

Re: Droopy Overhangs

Posted: Wed Feb 13, 2019 1:38 pm
by Orias
Reach out to the support team for help, at Include any pictures you have and information on the version of Cura LulzBot Edition used, the print profile used, and the brand of filament.