I am following the steps in this thread: https://forum.lulzbot.com/t/using-cura-2-3-1-with-lulzbot-3d-printers/4158/1
I am using the PLA_medium-quality_TAZ_single-extruder_0.35noz_cura.ini profile I downloaded from the link provided in the thread. When I import the profile it says it was successful but I don’t see it as a profile option. I’m using Cura 2.6.52. I tried with cura 3.2.32 but the profile failed to load with an error about version 1 expecting version 2.
I have a Taz 2 that I’m trying to setup basically from scratch. I’ve been having various issues with prints so I figured starting from scratch with this profile was a good clean slate rather than chase my tail around.