I tried to print the below vase (link at the bottom), I came back a few hours later and no center of the base - just a solid glob an inch high pile of filament with no center - this has happened before - the instructions on the fine print on the page - say something about vase mode - printing a solid block of filament sucks and is expensive
how the heck do I set / unset vase mode? what is the downside of it?
why don’t I see reference to vase? I did look here in the forum and there was a reference to “Expert” but can’t seem to find that, and the instructions did not make sense, I am very new to the whole 3D printing thing and don’t really have anyone I can ask for help.
what should I do?
thanks
Mini 2
Cura 3.6.3
mb