I just ordered my Taz; debated between that and a Prusa--decided to go Made in USA. Bummed I did not order it last week...
Anyway, is there a spare output so I can activate a solenoid? Where do I find the docs for this?
Thanks!
Adding solenoid
Re: Adding solenoid
You could activate one via the I2C port on the Rambo board. Search for "Rambo and Servo" for examples of how it can be done. You may need a mosfet if your solenoid draws sufficient current to be above the rating for the board.
Re: Adding solenoid
Thanks! I'll check it out.