## Calibration Cube Taz6

A forum dedicated to the stock LulzBot TAZ 3D Printer
OyarzoPablo
Posts: 20
Joined: Wed Mar 14, 2018 9:58 am

### Calibration Cube Taz6

Printed the calibration cube of Thingiverse: https://www.thingiverse.com/thing:1278865

From 20x20x20 mm
I got

X = 19.90
Y = 20.15
Z = 19.80

How do I proced to take these values closer to 20mm?

Keebie81
Posts: 104
Joined: Sat Dec 20, 2014 12:53 pm

### Re: Calibration Cube Taz6

You adjust the steps/mm, but for that small variance I wouldnt worry. 3d printing isnt going to get an exact measurement due to material shrinkage and such.

OyarzoPablo
Posts: 20
Joined: Wed Mar 14, 2018 9:58 am

### Re: Calibration Cube Taz6

In Cura or Setting on the Lulzbot?

I wanna get as close as I can, as I've seen many examples prints on the Lulzbot, Ender and Prusa.

zachah
Aleph Objects | LulzBot
Posts: 65
Joined: Mon Jul 31, 2017 9:20 am

### Re: Calibration Cube Taz6

The easiest way is going to be with Cura. Use the scale option and un-check Uniform Scaling.

Then do some cross multiplying to find our desired X Y and Y percentages values. In this case with your measurements that comes out to:
X 100.50%
Y 99.26%
Z 101.01%

You'll take your desired value (20) and multiply that by 100 (for 100 percent), then you'll divide by your measured value(X,Y,Z) to get your adjusted percentage.
20*100=2000
2000/19.90=100.502512563
2000/20.15=99.255583127
2000/19.80=101.01010101

OyarzoPablo
Posts: 20
Joined: Wed Mar 14, 2018 9:58 am

### Re: Calibration Cube Taz6

@zachah Worked great!
NOTE: if you do the test, be sure to rotate the model to match x and y axis. had problems for that.

1) Is there a way to make it permanent? on the setting for any imported STL?
2) What was the other not simpler way?

zachah
Aleph Objects | LulzBot
Posts: 65
Joined: Mon Jul 31, 2017 9:20 am

### Re: Calibration Cube Taz6

I'm not aware of a way to have Cura automatically do this when importing an stl.

The less simple way would be to adjust your X,Y, and Z steps/mm. The issue with this is that it can affect your auto-leveling if adjusted too much since the corner positions are more or less hard coded into the firmware.