Pause command in Gcode for S3D

Get answers & advice for all of your 3D printing & Free Software needs here!
Post Reply
Posts: 59
Joined: Fri Oct 12, 2018 11:55 am

Pause command in Gcode for S3D

Post by B-Hep-Spring » Sun Sep 15, 2019 12:27 pm

im trying to get my print to stop at a given place which I normally and regularly do on ultimaker and prusa BUT my taz has taken to stopping at given point wait, and then extract the material from printer Most annoying 2 hrs into a 4 hr print but I don't seem to be able to find what's causing it in my code so I did another pause routine

;Pause test
G91 ; set relative
G1 E-2.50.0 F1800 ; Retract
G1 Z50 F2000
G1 X20 Y20 F2000; move to X20 Y20 at F2000 speed
M0 S30 ; pause
G1 E3.0 F1000 ; purge 3mm fillament
G90 ; set Absolut
G92 E0.0 ; re set extruder length

can anyone see a problem with this?? Help appreciated

Posts: 36
Joined: Sun Feb 18, 2018 8:25 am

Re: Pause command in Gcode for S3D

Post by Aha » Thu Oct 03, 2019 7:59 pm

What was the result of this code? Try using it to print a single layer. I'm really interested in the same functionality but haven't done it yet. I'm happy to try helping with the code if you tell me what you're seeing?

Post Reply