Nelon X filament

Help with printing with specific plastic filaments.
Post Reply
Morris Washington
Posts: 1
Joined: Thu Sep 12, 2019 8:43 pm

Nelon X filament

Post by Morris Washington » Thu Sep 12, 2019 9:20 pm

Does anyone have experience printing with nylon X mini 2.

Aleph Objects | LulzBot
Posts: 9
Joined: Fri May 10, 2019 9:19 am
Location: US

Re: Nelon X filament

Post by Noah » Fri Sep 13, 2019 9:13 pm

When printing with Nylon X or other carbon fiber based abrasive filaments, it is important to use a hardened steel nozzle to avoid damaging your nozzle. The standard nozzle on the Mini 2's extruder is not hardened steel and so if you use Nylon X you will likely damage the nozzle. However if you want to look at getting one of the Lulzbot HS or HS+ tool heads, then you should be able to print abrasive filament just fine with some additional settings adjustments if they do not have a Lulzbot material profile in Cura.. This is because the HS and HS+ have hardened steel nozzles.

Post Reply