Mini Gen1 Update Cura & Firmware - Won't work

Look here for custom firmware, networked 3D printer hosts like OctoPrint, and more!
Post Reply
StarkFlyer
Posts: 2
Joined: Fri Oct 11, 2019 3:15 pm

Mini Gen1 Update Cura & Firmware - Won't work

Post by StarkFlyer » Fri Oct 11, 2019 3:27 pm

Last January I decided to try to update Cura from 21.08 with the original 1.0.2.2 firmware to Cura 3.2.32. Found I also had to update the firmware to 1.1.9.16. I kept E steps and Z offset to the same values. When trying to do a print I received the following console message, "Error: MINI Temp triggered, system stopped Heater ID: bed Error: Printer Halted. kill()called!

So I went back to the old versions and all okay. Been using the old versions since. Today I tried to update to Cura to 3.6.21. Had to up date firmware to 1.1.9.34. ran a print and received the same console message. Went back to older versions and all okay.

Wonder why I can not up date Cura?

StarkFlyer
Posts: 2
Joined: Fri Oct 11, 2019 3:15 pm

Re: Mini Gen1 Update Cura & Firmware - Won't work

Post by StarkFlyer » Thu Oct 17, 2019 2:14 pm

FYI. When I install the latest version of Cura I update the firmware via the automatic update, not custom update. I assume this is correct.

Is this how others update their firmware?
Can anyone think of what I might be doing wrong?

b-morgan
Posts: 311
Joined: Fri Aug 11, 2017 8:53 am

Re: Mini Gen1 Update Cura & Firmware - Won't work

Post by b-morgan » Thu Oct 17, 2019 2:19 pm

That is the procedure I use. There were multiple flavors of the original Mini so make sure you have selected the correct one. I'd call LulzBot support and if they answer, they should be able to help.

Post Reply